Proudly Made in USA 
General Repairs
For use when sealing connections and low pressure leaks (5 psi or under).
STEP 1
Peel away plastic liner from tape.
STEP 2
Press tape firmly on object, hold in place and begin first wrap completely over itself.
STEP 3
While holding tape in place, STRETCH while wrapping with a 2/3 overlap to ensure a proper seal.
STEP 4
Wrap the last stretch completely over the previous layer and press firmly.
Pressurized Sealing
Coming soon
Dispenser Load
STEP 1
Remove cap by pressing on thumb break while pulling upwards.
STEP 2
Press roll onto spindle.
STEP 3
Separate tape from liner. Pull liner until it is below liner spool.
STEP 4
Slide liner into spool. Pull liner tightly.
STEP 5
Gently pull tape as liner collects on spool.
STEP 6
Replace cap on dispenser.
Using the Dispenser
STEP 1
Pull tape to desired length. Position tape beneath the cutting blade.
STEP 2
Press button while gently pulling tape to cut the tape.
For Use as an Applicator
STEP 1
Pull out 2-3″ of tape. Begin wrapping the tape completely over itself 2-3″ before the repair.
STEP 2
Continue to stretch and wrap using a 1/2″ overlap. Continue wrapping 2-3″ beyond the repair.
STEP 3
When the desired wrap is achieved, pull out 2-3″ of tape. Cut the tape by gently sliding it under the cutting blade and pressing the button.
STEP 4
Wrap the final piece of tape completely over itself by hand.
Grip Wrap Directions
STEP 1
Begin by peeling the
liner away from the
silicone grip wrap.
STEP 2
Press the grip wrap firmly on the object being wrapped and wrap it over itself one time.
STEP 3
While holding the tape
in place, begin wrapping
the grip wrap with a
1/2 overlap, aligning the
ridges.
STEP 4
Continue wrapping the grip around the object without stretching it. This will allow for the ridges to be uniform across the wrap.
STEP 5
When the desired length is achieved, cut the grip wrap, leaving approximately 1-2″ to finish the wrap.
STEP 6
Wrap the final wrap over itself completely.
STEP 7 (optional)
To finish the ends, first
cut a 2-4″ piece of
Miracle Wrap.
STEP 8 (optional)
Wrap the Miracle Wrap around the end of the grip to make a smooth end.
STEP 9 (optional)
If you do not have Miracle Wrap, a utility blade can be used to make smooth ends. Cut all the way around the grip end in a straight line.
STEP 10 (optional)
Gently peel away the excess tape to create a smooth end.